Fagor BC-112 Manual download pdf (Page 10)

Setting the Temperature Control

• The unit has a single temperature zone. The

temperature can be set between 36ºF and 43ºF

(2ºC and 6ºC).

• When the unit is plugged in for the first time, the

unit will power up automatically to the preset

defaults. The default temperature is 38ºF (3°C).

• You can set the temperature by pressing the

UP and DOWN buttons. When you press the

UP or DOWN buttons, the displayed

temperature will change accordingly.

• The temperature will increase 1ºF or 1ºC if you

press the UP button once. The temperature will

decrease 1ºF or 1ºC if you press the DOWN

button once. The display will flash while you

make your selection.

TEMPERATURE DISPLAY

During normal operation, the temperature display on

the control panel always shows the SET

temperature. The temperature display will flash if

- A different temperature is being set.

- The temperature in the zone deviates by more

than 9°F or 5°C from the set temperature.

The temperature display flashing ensures that the

temperature cannot rise or fall un-noticed.

TEMPERATURE MEMORY FUNCTION

In the event of a power interruption (power surge,

breaker switch failure, etc.), the unit will remember

the last temperature settings and, when the power is

recovered, the cabinet temperature will go back to

the same set temperature as before the power

interruption.

TEMPERATURE ALARM

An alarm will sound if the temperature rises or falls

outside the temperature range. The temperature

display will flash at the same time.

The temperature the appliance is set at determines

the temperature the appliance recognizes as being

too warm or too cool.

The alarm will sound and the temperature display

will flash:

- If the temperature inside the appliance is very

different from the temperature set. This does not

include the very first time the unit is turned on.

- When there has been a lengthy interruption to

the power supply.

- When too many items have been put into the

unit at one time. This can be as a result of

holding the door open too long or from

overloading the unit past its recommended

capacity.

- When the door is not been closed tightly.

THE ALARM CAN BE DEACTIVATED BY

PRESSING THE POWER BUTTON

DOOR ALARM

If the door has been left open for more than 60

seconds, the alarm will sound.

Once the set temperature has been reached in the

appliance, the alarm stops and the relevant

temperature display stops flashing. However, if the

noise disturbs you, you can switch the alarm off

before this if you wish by pressing the POWER

button once. The alarm will stop. The temperature

display continues to flash until the set temperature

has been reached. The display then lights up

constantly and the alarm system is fully active again.

INTERIOR LIGHT

The interior light makes it easy to view your

beverage labels and enhances the display of your

collection. Touching the LIGHT button toggles

between 2 modes of operation for the internal lights:

functional (default) mode and showcase mode. If

you are in functional (default) mode, the lights will

turn on only when the door is open. If you are in

showcase mode, the lights will remain on whether or

not the door is open.

The unit is equipped with a LED light fitting system.

To change the LED light fitting please contact the

service department.

NOTE: Please use only the original LED light fittings

provided by the manufacturer.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

Comments to this Manuals

No comments

Fagor BC-112 Manual Page 10

Comments to this Manuals

Related products and manuals for Unknown Fagor BC-112