Fagor FFJ1650X Installation Manual download pdf (Page 40)

Noises, inconveniences or minor breakdowns

PROBLEM ADVICE

Frost forms inside your

appliance

- be careful not to open your appliance’s door too often, and not

to leave it open.

The external walls are warm

- this is quite normal. It stops condensation forming on the outside

of your appliance.

Drops of water appear on your

appliance’s external wall

- When your home’s heating is not on (for example in spring and

autumn) and the ambient air is humid,some condensation may

form on your appliance’s outside walls. This is not dangerous at all

and your appliance continues to operate quite correctly.

Droplets of water or ice forms

on the appliance’s rear wall

- this is quite normal. This is a particularly cold and damp area of

the appliance and droplets of water and frost can form here when

your appliance is operating normally. This frost is regularly

eliminated during your refrigerators automatic defrosting cycles.

Droplets stagnate at the back

of the appliance

- check that the drain hole is not blocked. If it is, release it with a

stick or a metal wire as shown in the section in "Ongoing

maintenance of your appliance".

The door is difficult to open

- it is normal for the door to offer some resistance to being

opened,particularly when you have just shut it: a slight

underpressure forms in your appliance to ensure the door seals

perfectly. All you have to do is wait a few seconds before

re-opening.

The light inside the

refrigerator is out

- check that the thermostat is not in the

(0) position.

- check that your appliance is connected to the electrical supply.

- check that the circuit-breaker for your house has not cut out and

that the fuse has not blown or been unscrewed.

- check that the bulb has not burnt out, and refer to the section

"changing the light bulb".

1 2 ... 35 36 37 38 39 40 41 42 43 44

No comments

Fagor FFJ1650X Installation Manual Page 40